Joined: Wed Jul 11, 2007 9:27 pm Posts: 55 Location: USA
|
***I am trying actually let not my system deduct money if someone other end do not pick up the phone.
So i choose several step to test and there is another post under install ->billing from which it actually initiated.
step 1 : using progressive billing
i do not wanted let my system deduct money for first 60 seconds (THIS WAY I THOUGHT IF SOMEONE OTHER END DO NOT PICK UP AND RING AND HANG UP WITHIN 60 SECOND SYSTEM WILL NOT CHARGE). but if
disconnection charge is applied that will deduct. so this solution is not that
usable. the code is
stepchargeA : 0
charge A : 0.0001
timechargeA : 60 (means first 60 sec charge nothing rather very small amount above)
Billingblock A : 0 (no block it will exit once timchrgeA is done)
stepchageB : 0.02
charge B : 0.02
timechargeB : 99999(i do not want to go charge C maximum call duartion anticipated)
Billingblock B : 0 (no block it will exit once timchrgeA finished as it will be so large that timecharge will nevr be finish and alwys bill with this rate)
for above code selling rate defined same 0.02 and no disconnection charge.
"""""Pertaning this problem i want to ask if there any way i can make
listen in the IVR as selling rate 0.02 cents but when go billing block
after 60 seconds it charge according to that rate like if it set upon 0.04 cents. """"""
In the post install -> billing
stavros replied with the one when asking about this IVR problem
with that
; For free calls, limit the duration: amount in seconds
maxtime_tocall_negatif_free_route = 5400
thats why i pull it out again.
will there be any answer for this?
|
|