provided by Star2Billing S.L.

Hi,

I am trying to make a dial-plan allowing call termination from FreePBX's trunk, on specific a2b account.
- The DNID on incoming calls from trunk can be anything.
- The CLID can be anything and must be kept.

Up until now I have always used the CLID as base to associate out-going call to an A2billing user account to be billed for them. Now that I have to keep the original CLID, how do I bill the call to the right A2b user?

any pointers/ideas will be greatly appreciated,

tnx,

nir

The PBX registers to Asterisk using the credentials you set up in A2Billing. because one of these credentials is the accountcode, the system will automatically associate the calls with the right user.

Note that you cannot have authentication via username and secret, and authentication by callerID in the same agiconf

Joe

thank you,

can you tell me which variable do I need to modify on the new agiconf, to remove the Identification by user/pass, and allow identification by accountcode passed?

CID_Enable from memory.

Joe

any variables I need to disable?