Joined: Wed Jul 11, 2007 9:27 pm Posts: 55 Location: USA
|
Hi there,
I wanted to charge different for different access no. Like for toll free no extra charge. I think this is been several post but nothing actually work
for me.
I follow the same way as creating two rate card with two different dnid prefix I figure out when put dnid prefix 1866 i get error message when dialing destination. error shows either i did not attach rate card to the call plan or there is no rate created for this rate card for this country code
which is totally wrong.
If i set dnid pefix all it works fine again.
so problem is located at dnid prefix.
I created 2 agi-cnf context where for two different access no access respectively. one context have defined extracharge fee ,extracharge did
no set up other as usual blank(because i tried different way than)
In this circumatances where could be wrong?
Is someone can get me a point about that DNID prefix that i told earlier.
regards
Mushfiq
|
|