Hello,
I think I have my A2Billing almost working the way I would like. JRoper from the PBXIAF forum suggested I ask for specific advice here.
In short, I have "special" customers on contract. I'd like to use the calling card functionality to "validate" clients, and if valid send them to a specific Queue in FreePBX for special handling.
The following works: I have a DID configured; I can dial in and control gets passed to A2B and it asks for the card number. I enter the valid card number and then I am asked for a destination. No destinations work, as I have not configured outbound dialing, as I do not want this. I'm stuck here.
I would like to change that after a valid card number is entered, if valid, the call is routed to a specific queue already configured in FreePBX.
There is 1 DID to be shared amongst ALL account holders (so Incoming DID rules didn't seem to be what I need, as I had to assign it to a customer account number). I expect each contract/account to have it's own "card number" assigned via the customer management (test account is successful).
Where do I need to go from here to get a validated card to automatically be routed to a queue rather than prompt for a destination?
Thanks!
Wayne P.
|