provided by Star2Billing S.L.

Hello everyone. I am trying to disable the balance info after authentication on the a2billing ivr.

I have the following settings in my a2billing.conf file.

say_rateinitial = NO
say_duration = NO
say_goodbye = NO
say_balance_after_auth = NO
say_balance_after_call = NO
say_timetocall = NO

When it look into the agi debug i still get:
AGI Rx << SET VARIABLE CHANNEL(language) "en"
AGI Tx >> 200 result=1
AGI Rx << STREAM FILE prepaid-you-have "#" 0

I think the prepaid-you-have plays the balance( 90 usd) and then after i dial the number and press "#" i get the prepay-you-have again and the total amount of minutes available followed by prepaid-minutes.

I can provide the agi debug if necessary.

Any ideas on how to turn off these two voices?
Thanks a lot
Her

The agi-conf controls the call in progress.

From a2billing version 1.4, the agi-conf is controlled from the Database, not from the a2billing.conf file.

Joe