Joined: Sat Feb 19, 2011 6:19 am Posts: 38
|
Hello ı am newbie in a2billing. I am currently using a2billing 1.9.3 and Asterisk 1.6.2.17.2.
in agi-conf2(which i am using for sip calls) i set Auto Set CLID to "yes" and CLID Sanitize to " CID" which means that if a account has a callerid defined it will be shown as clid.
But what will happen in case if more than one caller id is assigned to that customer. To test this i assigined two caller id to a customer and tried to make call. always the first caller id in the list is assigned as clid.
Is there any way to select which caller id to be used as clid.
Some times ago i was using voip from a viop provider and they found a solution it the following way
in xlite we were setting username as one of my pre assigned callerid and in auth id i was entering my username while registering with xlite and also in the same manner in ata device.
Is this possible to do with a2billing?
To give an example my customer(014123454) set two caller id say 0044xxxxxxx and 0044yyyyyy as caller id in a2billing and while registering to the server he will enter his username as his callerid ( either 0044xxxxxx or 0044yyyyy) and he will enter auth id as 014123454.
In this way he will use one of his predifened callerid as clid.
Or is there any other way of defining clid while registering to a2billing.
Yours Rock
|
|