How to allow multiple ip range in a SIP trunk for wholesale?

stp_abhi · **Joined:** Fri Apr 09, 2010 8:57 am **Posts:** 4

How to allow multiple ip address range in SIP trunk as hosts for IP authentication... Thanks in advance..

jroper · **Joined:** Fri Jun 23, 2006 3:56 pm **Posts:** 4065

Hi

You can create multiple peers all attached to the same account, or you can create one sip.conf entry by hand with multiple host ip addresses.

Joe

stp_abhi · **Joined:** Fri Apr 09, 2010 8:57 am **Posts:** 4

jroper wrote:

Hi

You can create multiple peers all attached to the same account, or you can create one sip.conf entry by hand with multiple host ip addresses.

Joe

if there are one or two ip's we can separate using comma as delimiter... but if we want to allow a range of ip addresses how to add them ???

stp_abhi · **Joined:** Fri Apr 09, 2010 8:57 am **Posts:** 4

stp_abhi wrote:

jroper wrote:

Hi

You can create multiple peers all attached to the same account, or you can create one sip.conf entry by hand with multiple host ip addresses.

Joe

if there are one or two ip's we can separate using comma as delimiter... but if we want to allow a range of ip addresses how to add them ???

I want to allow a subnet of ip's in host... for ex .. 128.XXX.XXX.48 to 128.XXX.XXX.60 .Thanks in advance..

jroper · **Joined:** Fri Jun 23, 2006 3:56 pm **Posts:** 4065

http://www.voip-info.org/wiki/view/Asterisk+sip+host

This is not an Asterisk support forum, but it does not look like a range of IP addresses can be used for registration, and if you think about it, impossible to implement if you intend sending calls to them.

My advice is to get the endpoints to register using username / password authentication, or to use an identifying prefix, or to use the allow / deny directives.

Joe

johnvam · **Joined:** Fri Nov 13, 2009 8:04 pm **Posts:** 24

Is it possible to have for the same account code two IPs for authentication???

Thank you!

jroper · **Joined:** Fri Jun 23, 2006 3:56 pm **Posts:** 4065

Hi

Yes it is, simply create another SIP entry, and set the accountcode directive.

Joe

johnvam · **Joined:** Fri Nov 13, 2009 8:04 pm **Posts:** 24

I did it but with no result...

Only the first IP authentication is working... When I use the second IP the call progress stuck at INVITE mode...

provided by Star2Billing S.L.

How to allow multiple ip range in a SIP trunk for wholesale?

Who is online