Hai, I'm nubie on asterisk...
I'm start with install trixbox CE 2.8 with a2billing 1.6 on this site
http://trixboxer.com/blog/set-up-a2bill ... -asterisk/after finish installing, I do general setup like
* Set up trunk * Set up callplan * Setup rate plan * add rate table to callplan * add rates * add customer * test.
but on the test, after dial a number destination, chose language, and say balance, enter number destination. say, "the number u'r calling not available"
is there some setup I miss?
sorry for my language
thanks before
anditya